Skip to content
We independently pick everything we recommend. We earn a commission when you buy through our links, at no extra cost to you. Learn more ›
Amazon Black Friday Week deals

Laser Engraving Time Calculator

A raster engraving is drawn one line at a time, so the job time comes down to how many lines there are and how long each one takes. Enter the design size, the speed and the DPI to get an estimate before you press start.

Engraving time

Measured along the direction the head scans, usually left to right.
Line interval: 0.100 mm.
Extra travel past the edge of each line, if your software adds it.
33 min 20 s

    This is travel time at the set speed. The head also slows down and speeds up at the end of every line, and the software adds moves between shapes, so the real job runs longer, most of all on small designs at high speed.

    How the calculation works

    1. Line interval. Millimeters between lines = 25.4 ÷ DPI. At 254 DPI the lines are 0.1 mm apart.
    2. Number of lines. Design height ÷ line interval. A 100 mm tall design at 0.1 mm is 1,000 lines.
    3. Time per line. (Design width + overscan on both sides) ÷ speed. In unidirectional mode the head travels back without burning, so each line takes twice as long.
    4. Total. Lines × time per line × passes.

    Example: 100 × 100 mm at 3,000 mm/min (50 mm/s) and 254 DPI is 1,000 lines of 2 seconds each, or 33 minutes 20 seconds.

    Ways to shorten a job

    • Lower the DPI. Half the DPI is half the lines and half the time. Wood and leather often show no difference once the lines already overlap.
    • Put the long side along the scan axis. Fewer, longer lines finish sooner than many short ones, because the head spends less of the job slowing down and turning around.
    • Raise the speed with the power. Speed and power trade against each other. The power and speed converter shows the matching pair.
    • Use bidirectional scanning when the machine holds alignment in both directions.

    Vector cutting follows the outline instead of scanning lines, so its time is path length ÷ speed and this calculator does not apply.