Skip to content
We independently pick everything we recommend. We earn a commission when you buy through our links, at no extra cost to you. Learn more ›
Amazon Black Friday Week deals

Laser Power and Speed Converter

Settings shared online are written for one particular laser. If yours has a different output power, the same speed and percentage will burn too light or too deep. This converter finds the speed that puts the same energy into each millimeter of travel.

Same energy at a different power

Optical output power of the laser the setting came from.
6000 mm/min

    A starting point, not a finished setting. Spot size, wavelength, focus and the material batch all change the result, so run a small test grid around this speed on scrap before the real piece.

    How the conversion works

    1. Power at the material. Laser power in watts × power percentage. A 10 W laser at 80% delivers 8 W.
    2. Energy per millimeter. Watts ÷ speed in mm/s gives joules per millimeter. 8 W at 50 mm/s is 0.16 J/mm.
    3. Matching speed. Your laser’s watts ÷ that energy per millimeter. A 20 W laser at 80% is 16 W, so 16 ÷ 0.16 = 100 mm/s, or 6,000 mm/min.

    Twice the power at twice the speed lays down the same energy in half the time.

    Limits of the conversion

    • Use optical output power. Many diode lasers are advertised by electrical input power, which is several times higher than the light they emit. The spec sheet lists both.
    • Same laser type only. Diode, CO2 and fiber lasers have different wavelengths, and materials absorb each one differently, so a CO2 setting does not convert to a diode.
    • Spot size changes the result. A larger spot spreads the same energy over a wider line and marks lighter.
    • Very fast lines can run short. On small designs the head may never reach the set speed before it has to slow down again.

    Run a small test grid around the converted speed on scrap of the same material before the real piece.