Skip to content
We independently pick everything we recommend. We earn a commission when you buy through our links, at no extra cost to you. Learn more ›
Amazon Black Friday Week deals

Laser DPI and Line Interval Calculator

Laser software asks for resolution in two ways: DPI, or line interval in millimeters. They are the same setting written differently. Enter either one, add the engraving size, and the calculator also gives the pixel dimensions the image should have.

DPI, line interval and image size

Dots or lines per inch.
Type an interval to get the DPI.
From the machine's spec sheet. Used to show the highest DPI that still adds detail.
254 DPI = 0.100 mm line interval

    One inch is exactly 25.4 mm, so line interval in millimeters is 25.4 divided by DPI. Scale the image to these pixel dimensions before importing so the software does not resample it.

    How the numbers relate

    • DPI to line interval. Line interval in mm = 25.4 ÷ DPI. 254 DPI is 0.1 mm, 318 DPI is 0.08 mm, 508 DPI is 0.05 mm.
    • Image pixels. Pixels = size in inches × DPI. A 100 mm (3.94 in) wide engraving at 254 DPI needs an image 1,000 pixels wide.
    • Spot size sets the ceiling. Once the line interval is smaller than the laser spot, neighboring lines overlap. That makes the burn darker but cannot add detail finer than the spot. Highest useful DPI = 25.4 ÷ spot size in mm.

    Choosing a DPI

    Start from the spot size on the machine’s spec sheet and set the line interval close to it. Go finer when you want a darker, more even fill, and coarser when speed matters more than a solid tone. Higher DPI also means more lines, so check the job length with the engraving time calculator.

    Resize the photo or artwork to the pixel dimensions shown before importing it. An image with far fewer pixels looks blocky, and one with far more is thrown away by the software when it resamples.